Panamax Hybrid Rack Mount Ups And Power Conditioner - MX5102

Category : Power Conditioners
SKU : MX5102


Panamax MX5102

Combines Power Management, Surge Protection with AVM and Battery backup to provide the Complete Solution.

Panamax's MX5102 is specially designed and engineered for home theater systems. In addition to power management the battery backup prevents processor controlled devices and hard-drive based sources from losing critical data and set up configurations, as well as allowing for a proper shut down procedure.


Battery Backup

MX5102 prevents critical equipment from losing setup configuration, stored data and hard-disk crashes. Shuts off projection equipment via IR control to allow the projector bulbs to go through a proper cool-down cycle before shutting off.


Improves Picture and Sound Quality

Level 3 Power Cleaning and Linear Filtration eliminates common symptoms of contaminated power (including loss of detail, pops, hisses, hums and visual artifacts) and allows your A/V equipment to perform up to its full capability.


Reduces Cross-Contamination Between Components

The MX5102 is designed to provide noise isolation between four isolated outlet banks including 2 high current, and 2 battery backup outlets so that any noise created by an A/V component can not contaminate the power going to equipment plugged into another outlet bank.


Monitors Incoming Line Voltage and Provides a Visual Indication of Power Level

Panamax's patent pending AVM circuitry continuously monitors the incoming power as displayed on the digital voltmeter. In case of an undervoltage or an overvoltage, a flashing red LED will be displayed on the front panel, and power to the connected equipment is automatically turned off for all outlets except for the battery connected outlets, if either of these conditions is detected. When voltage returns to a safe level, power to the equipment is automatically reconnected.

Panamax MX5102 Features at a Glance

Battery Backup

600VA UPS, 2 Outlets

Clean Power Level 3

Improves picture and sound quality by eliminating noise across the entire AC bandwidth. Sixty (60%) more efficient at eliminating noise than single stage linear filtration (Level 2).

4 Isolated Outlet Banks

Isolating outlet banks from one another prevents noise contamination between components.

High Current Outlets

2 outlets for equipment with high power demands (Amps/Subwoofers).

Digital Volt Meter

Monitor the voltage supplying your home theater equipment.

AVM (Automatic Voltage Monitoring)

Protects equipment against prolonged over/ under voltages by disconnecting the power and reconnecting it when safe power returns.

12 Volt Trigger

Allows source equipment to activate or deactivate the outlets on the MX5102.

Power Sequencing

Guards against blown fuses and potentially damaging speaker thump by automatically powering outlets on and off in sequence.

10 Outlets

4 Switched, 2 Battery Backup, 2 Switched High Current, 2 Always On.

Dual Learning IR Function

Panamax's Patent-Pending Learning IR Function lets you program the UPS to send standby or shut-down commands to components such as DLP ceiling projectors.

FamilyRack Mount
Line Voltage120 (Volts)
BlueBOLT EnabledNo
Number of Outlets10
Number of Isolated Banks4
Outlet DescriptionsAll 10 outlets filtered, and surge protected. Bank 1 is always on Bank 2 is switched by front panel power button or low voltage trigger Bank 3 is high current and switched by front panel power button or low voltage trigger Bank 4 is always on and backed up by battery
Rack MountableYes
Rack Ears IncludedYes
Front Panel Meter(s)LED display indicates incoming line voltage or estimated minutes of backup time
Front Media Light(s)No
ControlOn/Off control via front panel power button or low voltage trigger
Low Voltage Trigger3 - 18V DC In
AC Power Cord10 ft, captive
Dimensions17" W x 13" D x 4" H
Weight27 lbs.
Battery Backup
Output Frequency60 Hz ± 1%
UPS Output Capacity600VA, 360W @ 0.6pf
Regulation Output Range120 ± 5% Simulated Sine Wave
UPS Backup Time (Full Load)3 minutes
Transfer Time< 10ms
AC Protection
AC Protection TechnologyAutomatic Voltage MonitoringProtect or disconnect
Automatic Voltage ShutoffYes
Under-Voltage Shutoff90V ± 5V
Over-Voltage Shutoff150V ± 5V (fast rise)132 ± 5V (slow rise)
Maximum Current Rating12 (Amps)
Filtration TechnologyRFI/EMI Filtration
Filtration Rating30dB min from 100kHz-2MHz50dB max @ 270kHz
Signal Line Protection
Signal Line Protection1 LAN 1 Tel3 Cable/Satellite
Shipping Info
Length22 (Inches)
Width17.7 (Inches)
Height9.4 (Inches)
Weight32.7 (Lbs)
Unit of MeasureEach
Master Pack Qty28
Other Specifications
LAN Protection - Wires Protected8-Wires
LAN - JacksRJ-45
LAN - Compatibility10/100bT
LAN - Clamping Level50V
Telco Protection - Wires Protected2 Wires, 1 Pair (4, 5)
Telco - JacksRJ-11
Telco - Fuseless/Auto-ResettingYes
Telco - Clamping Level270V
Telco - Suppression ModesMetallic & Longitudinal
Coax Protection - ShieldedYesCoax - Insertion Loss
Coax - HD 1080 i/p ReadyYes
Coax - Frequency Range0 MHz - 2.2 GHz
Coax - ConnectionsFemale "F", Gold Plated
Coax - Clamping Level75V
Coax - BidirectionalYes

Write a review