Furman 15A Standard Power Conditioner w/Lights and Digital Meter-M-8DX

Category : Power Conditioners
SKU : M-8DX


Literature

Furman M-8DX

Install an M-8Dx into the top slot of your rack, and the eight switched outlets in the rear panel will power up and protect all your equipment up to a 15-amp load. Illuminate your rack with two retractable, front panel lights. Monitor voltage with the digital meter display.

A Merit Series Power Conditioner is the perfect low-cost AC power solution for any rack mount system. The M-8Dx features two slide out, swiveling light fixtures to provide discreet illumination of your equipment on stages, in studios, and in other dark places. A dimmer knob lets you adjust the lamp brightness to just the right level.The M-8Dx also features a bright red, three-digit LED voltmeter that displays incoming voltage.

Applications

INSTRUMENT RIGS

You've got a rack for your effects, preamps, tuner...You're going to plug that into the wall? One big spike and your rig is up in smoke. Furman's standard level surge/spike protection defends your gear from the spikes and surges that are so common at gigs and practice spots. With Furman's standard level RFI/EMI filtration, you'll get a quieter tone without pops, crackles, and the local radio station coming out of your amp. Plus, dual pull-out lamps let you see your rack without turning the house lights on, while the digital voltmeter lets you monitor incoming voltage.

RECORDING

Can't track down where that noise is coming from? Your mix sounding flat? With Furman's standard level RFI/EMI filtration you'll lower the noise floor caused by the dirty AC power coming into your console or DAW. Furman's standard level surge and spike protection keeps your sensitive digital equipment from acting funny or burning up due to everyday spikes and surges. You can even monitor voltage changes, as the digital meter allows you to keep an eye on the incoming line voltage. With a 15A capacity and nine total outlets, it's enough to power your whole home studio.

DJ EQUIPMENT

Bars, clubs and other event venues have some of the worst power out there - from air compressors turning on and off to light shows pulling current loads up and down, the AC power can be a strain on the circuits in your rig. Furman's standard level protection and filtration keeps the bad stuff out. The dual pull-out front panel lights also let you discreetly see your board and gear without distracting from the show on the dance floor.

PRO AUDIO

When you're out there gigging, you never know what kind of power you're going to get. The wear and tear on mobile rigs eventually takes it toll - that's why it's smart to plug into Furman's standard level protection and RFI/EMI filtration. It keeps your equipment safe and sounding clean. It keeps your equipment safe and sounding clean, while the digital voltmeter lets you monitor incoming voltage. Whether you're setting up a show at the local club or powering up the church band for their next service, make sure you give them power they can trust.

Furman M-8DX Features at a Glance

Noise Filtration

AC noise filtering to reduce radio frequency and electromagnetic interference (RFI/EMI)

Surge Protection

Spike & surge protection ensures equipment stays safe and your power stays clean

9 Total Outlets

8 rear panel outlets and 1 front panel convenience outlet

Digital Voltmeter

Digital voltmeter display incoming line voltage

15 Amp Rating

15 amp rating, with circuit breaker

"Protection OK" Indicator

Front panel indicator LED lets you know that your equipment is being protected

Wall Wart Spacing Indicator

Rear outlets have been spaced to accomodate even the bulkiest of wall warts and adapters

Front Panel Pull-out Lights

Two retractable incandescent light fixtures with dimmer control for convenient rack illumination

General
Line Voltage120 (Volts)
BlueBOLT EnabledNo
Power Factor TechnologyNo
Number of Outlets9
Number of Isolated Banks0
Outlet DescriptionsAll 9 outlets filtered and surge protected
Rack MountableYes
Rack Ears IncludedYes
Front Panel Meter(s)Digital Voltmeter
Front Media Light(s)Two 120V incandescent bulbs, 4 watts each
ControlFront panel: - On/Off switch - Light dimmer knob
Voltage RegulationNo
CompliancecTUVus
AC Power Cord6 ft. captive, 14 AWG, with 3-conductor Edison Plug
USB ChargingN/A
Low Voltage TriggerN/A
Dimensions19" W x 7.5" D x 1.75" H
Weight6 lbs
AC Protection
AC Protection TechnologyStandard spike and surge protection
Automatic Voltage ShutoffNo
Under-Voltage ShutoffN/A
Over-Voltage Shutoff130 VAC
Maximum Current Rating15 (Amps)
Filtration
Filtration TechnologyStandard Level RFI/EMI Filtration
Filtration RatingGreater than 26dB, 200Khz to 10 Mhz
Signal Line Protection
Signal Line ProtectionNo
Shipping Info
Length21.8 (Inches)
Width9.6 (Inches)
Height3.4 (Inches)
Weight7.1 (Lbs)
Unit of MeasureEach
UPC654061027959
Master Pack Qty6
Other Specifications
Spike Protection Modes:Line to Neutral
Energy Dissipation:150 joules
Peak Impulse Current:12,000 amps
Construction:Steel Chassis, Black Painted

Write a review