Furman 15A Standard Power Conditioner-M-8X2

Category : Power Conditioners
SKU : M-8X2


Literature

Furman M-8X2
Install an M-8x2 in to the top slot of your rack, and the eight switched outlets in the rear panel will power up and protect all your equipment up to a 15-amp load.

A Merit Series Power Conditioner is the perfect low-cost AC power solution for any rack mount system. The M-8x2 is designed for applications where lights are not required.

Applications
INSTRUMENT RIGS

You've got a rack for your effects, preamps, tuner...You're going to plug that into the wall? One big spike and your rig is up in smoke. Furman's standard level surge/spike protection defends your gear from the spikes and surges that are so common at gigs and practice spots. With Furman's standard level RFI/EMI filtration, you'll get a quieter tone without pops, crackles, and the local radio station coming out of your amp.

RECORDING

Can't track down where that noise is coming from? Your mix sounding flat? With Furman's standard level RFI/EMI filtration you'll lower the noise floor caused by the dirty AC power coming into your console or DAW. Furman's standard level surge and spike protection keeps your sensitive digital equipment from acting funny or burning up due to everyday spikes and surges. With a 15A capacity and nine total outlets, it's enough to power your whole home studio.

DJ EQUIPMENT

Bars, clubs and other event venues have some of the worst power out there - from air compressors turning on and off to light shows pulling current loads up and down, the AC power can be a strain on the circuits in your rig. Furman's standard level protection and filtration keeps the bad stuff out.

PRO AUDIO

When you're out there gigging, you never know what kind of power you're going to get. The wear and tear on mobile rigs eventually takes it toll - that's why it's smart to plug into Furman's standard level protection and RFI/EMI filtration. It keeps your equipment safe and sounding clean. Whether you're setting up a show at the local club or powering up the church band for their next service, make sure you give them power they can trust.

Furman M-8X2  Features at a Glance

Noise Filtration

AC noise filtering to reduce radio frequency and electromagnetic interference (RFI/EMI)

Surge Protection
Spike & surge protection ensures equipment stays safe and your power stays clean

9 Total Outlets
8 rear panel outlets and 1 front panel outlet

15 Amp Rating
15 amp rating, with circuit breaker

"Protection OK" Indicator
Front panel indicator LED lets you know that your equipment is being protected

Wall Wart Spacing Indicator
Rear outlets have been spaced to accommodate even the bulkiest of wall warts and adapters

General
Line Voltage120 (Volts)
BlueBOLT EnabledNo
Power Factor TechnologyNo
Number of Outlets9
Number of Isolated Banks0
Outlet DescriptionsAll 9 outlets filtered and surge protected
Rack MountableYes
Rack Ears IncludedYes
Front Panel Meter(s)No
Front Media Light(s)No
ControlFront panel: - On/Off switch
Voltage RegulationNo
CompliancecTUVus
USB ChargingN/A
Low Voltage TriggerN/A
AC Power Cord6 ft. captive, 14 AWG, with 3-conductor Edison Plug
Dimensions19" W x 3.75" D x 1.75" H
Weight4.9 lbs
AC Protection
AC Protection TechnologyStandard spike and surge protection
Automatic Voltage ShutoffNo
Under-Voltage ShutoffN/A
Over-Voltage Shutoff130 VAC
Maximum Current Rating15 (Amps)
Filtration
Filtration TechnologyStandard Level RFI/EMI Filtration
Filtration RatingGreater than 23dB, 200Khz to 10 Mhz
Signal Line Protection
Signal Line Protection No
Shipping Info
Length2.19 (Inches)
Width6.8 (Inches)
Height3 (Inches)
Weight4.8 (Lbs)
Unit of MeasureEach
UPC654061028307
Master Pack Qty6
Other Specifications
Spike Protection ModesLine to Neutral
Energy Dissipation:150 joules
Peak Impulse Current:12,000 amps
Construction:Steel Chassis, Black Painted

Write a review